RL24 RL28 RL34
  • RL Home Page
  • RL 24
  • RL 28
  • RL 34
  • Status 580
  • "The Venture"
  • News and Events
  • Register of Owners
  • Discussion Forum
  • Buy and Sell
  • Surveys

  • The RL Story
  • Picture Gallery
  • Cruising in an RL
  • Bay to Bay Race
  • Links to Other Sites
  • Tips & Modifications
  • Personal Thoughts
  • RL24 Nationals
  • RL24 State Titles
  • RL24 Owners Assoc.
  • RL24 Hall of Fame
  • RL24 Asn Newsletters
  • RL24 Asn AGM Minutes
  • North American RL24's
    		•
    WWW.RLYACHTS.NET
    RL24, RL28, and RL34 Trailable Yachts
    from Rob Legg Yachts

    RL Yacht Owner's Discussion Forum
    Your Name:
    Email Address:
    Password: ( Needed to edit or delete this message.)
    Message Title:
    Text of Message:
    Add an Image:
    		An image can also be attached to this listing. Click "Browse" to select the image file on your PC. It can be a JPEG or a GIF file. The file will be uploaded to the server, scaled to fit, and will appear beside the entry.

    Replying to:Volvo Penta 2001 will not start. HELP!!
    Hi guys, I am now at my wits end with this motor. Since the rebuild, with a full head service including new valves and valve guides, the engine has run, and run well. It did start to play up, losing revs and stalling, but we put that down to dirty filters. These have been replaced. The system primed. A new injector, injector pump and starter motor have since been installed. To the best of my knowledge, we have bleed the entire fuel system. I have checked the new injector with the new pump, and it is spraying a mist of diesel out when the engine is being cranked. The engine cranks over but still will not start. As it cranks a puff of greyish smoke comes out the exhaust with each stroke. We disconnected the exhaust pipe and water inlet to ensure it wasn't back pressure. We have checked the valves and they are opening and closing. (from the top of the head) I did notice at one stage, some air bubbles coming out fron under the injector. I thought that perhaps the brass injector sleave was worn. But after a couple of attempts at reseating the injector into the sleave, this problem seems to have stopped. Does anyone have any further suggestions? As I am at a loss to understand why this motor will not fire. We have even sprayed aero start (Ether) and oil into the air intake, and put oil directly into the injector tube (not into the injector itself), still with no result. My next step will be to remove the head and have it checked to ensure the valves are seating ect. (unless anyone else has a better suggestion? )